China OEM Machined Finish Wheels Has Scratch Repair Steps

1. Check the scars. If it is not damaged to the inside of the China OEM Machined Finish Wheels, you can simply repair it. Use paint dilution to wipe around the scars and remove dirt.

2, the deepest part of the scratch is difficult to remove the dirt, then you can use a toothpick to completely clean it.

3, in order to prevent accidental application of the unrelated part of the paint, it is best to carefully stick the adhesive tape around the scar.

4, finishing the tip of the brush, apply the modified paint, the paint shrinks slightly after drying, it is best to apply a little convex.

5. After painting, it takes about one week to completely dry. After drying, apply with soapy water on a water-resistant paper to smooth the surface.

6. After wiping with water-resistant paper, use a mixture to wipe out the light, then apply wax.

If you encounter deep scars on 17.5*6.0 Aluminum Alloy Wheels, the focus is on observing whether the metal surface is exposed. If you can't see the metal surface, it will not rust. You can concentrate on the lacquer. Use a pen tip to pick up the spot and wait until the paint is completely dry. To avoid this phenomenon, the car should be diligently flushing the rim when it is first used. The vehicle that is driven every day should wash the rim at least once a week. After flushing with clean water, brush it with a detergent. Then rinse with plenty of water.