The first step, check the scars, if not injured to the inside of the Flow Formed Aluminum Alloy Wheels, you can simply repair, use paint dilution, wipe around the scars, remove dirt.
The second step, the deepest part of the scratch is difficult to remove the dirt, then you can use a toothpick to completely clean it.
The third step, in order to prevent accidental application of the unrelated part of the paint, it is best to carefully stick the adhesive tape around the scar.
The fourth step is to arrange the tip of the brush and apply the lacquer. After the lacquer is dry, it will shrink slightly. It is best to spread it slightly.
After the fifth step, after painting, it takes about one week to completely dry. After drying, apply with soapy water on a water-resistant paper to smooth the surface.
The sixth step, after rubbing with water-resistant paper, use a mixture to wipe out the light, and then wax. If you encounter deep scars, the focus is on observing whether the metal surface is exposed. If you can't see the metal surface, it will not rust. You can concentrate on the lacquer. Use a pen tip to pick up the spot and wait until the paint is completely dry. To avoid this phenomenon, the car should be diligently flushing the Casting Low Pressure Aluminum Alloy Wheels when it is first used. The vehicle that is driven every day should wash the rim at least once a week. After flushing with clean water, brush it with a detergent. Then rinse with plenty of water. Our company is a professional manufacturer of automobile wheel hubs with reliable quality. Welcome new and old customers to visit our company and seek common development.
Copyright © Zhenjiang YuJiu Intelligent Equipment All Rights Reserved
