Home > News

Tell You A Few Taboos To Pay Attention To When Replacing A Car Wheel

Oct. 08, 2019

Find here details of OEM Flow Forming Wheels on our website. Today we would like to talk about a few taboos to pay attention to when replacing a car wheel.


The size and width of the hub is a very important set of data. The larger the size, the thinner the tire should be, because the circumference of the tire should be kept as much as possible, otherwise the speedometer will be biased. The thinner the tire, the more obvious the feeling of the road surface. The wider the wheel, the wider the tire can be loaded, although it will increase fuel consumption, but the larger the grounding area, the more stable the grip, and the friend who considers the performance of the car should reasonably replace the wider tire.


OEM Flow Forming Wheels

OEM Flow Forming Wheels


Taboos are shared by OEM Flow Forming Wheels Supplier for changing the hub:


1. It is to use too large a wheel. A lot of people think that the wheel hub is ok if it is installed without touching the outer sheet metal. In fact, the wheel is removed and the structure inside is carefully taken. There are many places that are very easy to get stuck, especially after the car is opened and the shock will be on the bumpy road. compression. Therefore, if you change the big wheel hub, you should use it properly, and you can't just ask for the beauty and finally get the car. Also pay attention to the width of the rim.


2. The brake calipers are stuck to the rim. Because of the safety problems that are currently being produced, the large brake calipers are often used, and the 4pot calipers are much larger than the singlepot.

In such cases, the rim is not enough for the offset and the design is not suitable, and it is often easy to get stuck in the brake caliper. Fortunately, this situation is easy to find, once you put on the wheel and there is a friction sound, just change it.


3. The width of the tire. When you run, you should carefully observe the friction caused by friction on the inside and outside of the tire. Too wide tires are also easily caught by some parts.


We also have ODM Flow Forming Wheels. If you need any information about it, feel free to contact us.


Zhenjiang YuJiu Intelligent Equipment

Copyright © Zhenjiang YuJiu Intelligent Equipment All Rights Reserved

Contact Us
  • E-mail: jack@safewheels.cn
  • Tel: +86 15262913899
  • Tel: +86 511 8317 3198
  • Add.: Zhenjiang Factory:No.19 Wu Feng Shan Road, Dagang New District, Jiangsu, Zhenjiang City, China
  • Add.: Siyang Factory:No.219 East Zhong Xing Road, Siyang Economic Development Zone, Suqian City, China
Follow Us

Sitemap | Powered by